LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1995 >> Tercel Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical (1.5L 4-CYL) >> Removal & Installation >> Crankshaft Front Seal >> Removal & Installation (Oil Pump Installed)

Removal & Installation (Oil Pump Installed)

  1. Remove timing belt and crankshaft sprocket. See TIMING BELT . Using a knife, cut seal lip from seal. Pry seal from oil pump body. DO NOT  damage sealing surfaces.
  2. To install, apply grease to lip of new seal. Using hammer and Seal Installer (SST 09309-37010), install seal until seal surface is even with oil pump body. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals