LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1995 >> Land Cruiser >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Component Testing >> Fuel Sending Unit Tests >> Fuel Sending Unit Resistance Test

Fuel Sending Unit Resistance Test

  1. Turn ignition off. Remove fuel sending unit from tank. Connect ohmmeter to appropriate sending unit terminals. Refer to the FUEL SENDING UNIT CONNECTOR TERMINALS  table. Sending unit connector terminals are located opposite of the harness connector terminals. See Figure.
  2. Move sender arm and ensure resistance is within specification. See FUEL SENDING UNIT RESISTANCE SPECIFICATIONS  table. After a short delay, gauge pointer should move when sender is connected and float arm is moved.
FUEL SENDING UNIT CONNECTOR TERMINALS

Model Sending Unit Connector Terminals No.
Land Cruiser 4 & 5
FUEL SENDING UNIT RESISTANCE SPECIFICATIONS

Float Position Ohms
Full 3
Half N/A
Empty 110
scientia non olet · About LEMON Manuals