LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1994 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Overhaul - A-240E/L, A-244L & A-245E) >> Component Disassembly & Reassembly >> Direct Clutch >> Disassembly

Direct Clutch: Disassembly

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove snap ring from direct clutch drum. Remove flange, discs and plates. Note number and location of components. See Figure. Using Clutch Spring Compressor (09351-32070) and press, compress spring retainer and springs. Remove snap ring, clutch spring compressor, spring retainer and piston return springs.
  2. Install direct clutch on oil pump. Apply compressed air to oil pump oval shaped oil passage to remove piston. See Figure. Remove direct clutch from oil pump. Remove clutch piston "O" rings.
scientia non olet · About LEMON Manuals