LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Overhaul - A-241E/H/L & A-243E) >> On-Vehicle Service >> Right Side Gear Shaft Seal (A-241H) >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 1994 Toyota MR2, 1993 Toyota MR2, 1993 Toyota Celica, 1992 Toyota MR2, and 1992 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove dust cover and fender apron seal. Drain gear oil. Remove bearing lock bolt. Remove snap ring. Pull out drive shaft with Puller (09308-00010). Using a screwdriver, remove oil seal.
  2. To install, coat lip of seal with grease. Using Replacer Set (09608-30022), drive seal into case. Seal should be recessed .012"(0.30 mm) when installed.
  3. Using Remover/Installer (09520-32012), install side gear shaft. Install snap ring and drive shaft. Ensure drive shaft cannot be pulled out. Fill differential with ATF. Install fender apron seal and dust cover.
scientia non olet · About LEMON Manuals