LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Overhaul - A-241E/H/L & A-243E) >> On-Vehicle Service >> Control Valve Assembly >> Removal

Control Valve Assembly: Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 1994 Toyota MR2, 1993 Toyota MR2, 1993 Toyota Celica, 1992 Toyota MR2, and 1992 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean exterior of transaxle. Remove oil pan plug. Drain transaxle. Remove oil pan and gasket. Discard gasket. Remove oil strainer. Note location of magnets in oil pan. Remove magnets. Examine particles in pan. Steel (magnetic) particles indicate bearing, gear, or plate wear. Brass (non-magnetic) particles indicate bushing wear.
  2. Remove tube bracket. Note location of oil tubes, and remove oil tubes. Disconnect solenoid wiring connector(s). Remove manual detent spring. Disconnect throttle cable from cam. Remove control valve assembly. Remove 2nd brake apply gasket.
scientia non olet · About LEMON Manuals