Converter Sleeve RUNOUT Test
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- Temporarily mount torque converter to drive plate. Mount a dial indicator with needle resting on converter sleeve. See Fig 2. Rotate converter. If runout exceeds .012" (.30 mm), ensure converter is properly mounted to drive plate.
- If converter is properly mounted and runout exceeds specification, replace torque converter. Mark position of converter on drive plate to ensure correct installation. Remove converter from drive plate.