Throttle Cable: Installation
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- Install throttle cable in transaxle case. Ensure cable is fully seated. Install retaining bolt and plate. Install control valve assembly. On new throttle cables, stopper must be staked on inner cable. Bend cable in approximately 7.87" (200 mm) radius.
- Pull inner cable lightly, until a slight resistance is felt, and hold in place. Stake stopper on inner cable, leaving a .031-.059" (.78-1.49 mm) gap between cable housing and stopper. See Fig 1.
- Adjust throttle cable and neutral safety switch (if necessary). See appropriate AUTOMATIC TRANSMISSION SERVICING article in the TRANSMISSION SERVICING section. Install manual shift lever. Install transaxle control cable. Test drive vehicle.