LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Overhaul - A-240E/L, A-244L & A-245E) >> Electronic Component Testing >> Overdrive Solenoid

Overdrive Solenoid

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect overdrive solenoid connector at transaxle. Connect solenoid to battery voltage and ground. Solenoid should operate and clicking should be heard. Connect ohmmeter between solenoid terminals and note reading. Resistance should be 11-15 ohms. Replace as necessary.
  2. Reconnect solenoid connector. Disconnect coolant temperature switch. Turn ignition switch to ON position. Operate overdrive switch. Solenoid should click when switch is turned to ON position. Turn ignition to OFF position. Reconnect coolant temperature switch. Replace solenoid as necessary.
scientia non olet · About LEMON Manuals