Valve Body Retainer Specifications Tables: Notes

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

UPPER VALVE BODY RETAINER SPECIFICATIONS ⁽¹⁾

Application (Letter ID) ⁽²⁾

Height: In. (mm)

Accumulator Control Valve ("A")

.591 (15.00)

Cut-Back Valve ("B")

.630 (16.00)

Low Or 2nd Coast Modulator Valve ("C")

.835 (21.20)

⁽¹⁾	Width is .197" (5.00 mm) for all retainers.

⁽²⁾	For retainer locations, see Fig 2.

LOWER VALVE BODY RETAINER SPECIFICATIONS ⁽¹⁾ ("E" SERIES)

Application (Letter ID) ⁽²⁾

Height: In. (mm)

Secondary Regulator Valve ("A")

.362 (9.20)

All Other Valves

.453 (11.50)

⁽¹⁾	Width is .197" (5.00 mm) for all retainers.

⁽²⁾	For retainer locations, see Fig 5.

LOWER VALVE BODY RETAINER SPECIFICATIONS ⁽¹⁾ ("L" SERIES)

Application (Letter ID) ⁽²⁾

Height: In. (mm)

3-4 Shift ("A"), Low Modulator ("C"), Lock-Up Signal ("F"), Detent Regulator ("G") & Low Coast Shift Valve ("J")

.453 (11.50)

2-3 Shift ("B"), Intermediate Shift ("D"), 1-2 Shift ("H"), & Secondary Regulator ("K") Valve

.362 (9.20)

3-4 Shift ("E") & 3rd Coast Shift Valve ("I")

.315 (8.00)

⁽¹⁾	Width is .197" (5.00 mm) for all retainers except ("E") and ("I"). Retainers ("E") and ("I") width is .236" (6.00 mm).

⁽²⁾	For retainer locations, see Fig 5.

Fig 1: Exploded View Of Upper Valve Body

Fig 2: Upper Valve Body Check Ball, Pin & Retainer Locations

Fig 3: Exploded View Of Lower Valve Body (A-240E, A-241E & A-244E)

Fig 4: Exploded View Of Lower Valve Body (A-240L, A-241L & A-243L)

Fig 5: Identifying Lower Valve Body Retainer Locations