LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Overhaul - A-240E/L, A-244L & A-245E) >> Component Disassembly & Reassembly >> UNDERDRIVE Clutch & No. 3 One-Way Clutch >> Disassembly

UNDERDRIVE Clutch & No. 3 One-Way Clutch: Disassembly

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove one-way clutch and thrust washer from under- drive clutch drum. Remove snap ring from underdrive clutch drum. See Figure. Remove flange, discs and plates from clutch drum. Note number and location of components. Using Spring Compressor (09351-32070) and press, compress return spring plate.
  2. Remove snap ring. Remove return spring and spring plate. Install oil seal rings to transaxle case (if necessary). Install underdrive clutch to transaxle case. Apply compressed air to oil passage in transaxle case to remove piston. See Figure. Remove "O" rings from piston.
scientia non olet · About LEMON Manuals