LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Overhaul - A-240E/L, A-244L & A-245E) >> Component Disassembly & Reassembly >> Rear Planetary Gear >> Disassembly

Rear Planetary Gear: Disassembly

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check No. 2 one-way clutch operation. Hold outer race and rotate hub. Hub should rotate freely counterclockwise and lock clockwise. See Figure.
  2. Remove thrust washers from both sides of planetary gear. Separate No. 2 one-way clutch and planetary gear. Remove snap rings and side retainers from No. 2 one-way clutch. Note position of No. 2 one-way clutch and remove from outer race. See Figure.
scientia non olet · About LEMON Manuals