LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Overhaul - A-240E/L, A-244L & A-245E) >> Component Disassembly & Reassembly >> Front Planetary Gear >> Inspection

Front Planetary Gear: Inspection

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all parts with solvent. Dry parts using compressed air. Check thrust bearings, races and one-way clutch for wear or damage. Replace if necessary.
  2. Measure inside diameter of sun gear flange bushing. Standard inside diameter should be .867-.868" (22.03-22.05 mm). Maximum inside diameter is .870" (22.10 mm). If inside diameter exceeds specification, replace flange.
  3. Measure planetary pinion gear thrust clearance. Standard clearance should be .008-.020" (.20-.50 mm). Maximum clearance is .020" (.50 mm). If clearance exceeds specification, replace planetary gear. See Figure.
  4. Measure inside diameter of ring gear flange bushing. Standard inside diameter should be .749-.750" (19.03-19.05 mm). If inside diameter exceeds specification, replace flange.
scientia non olet · About LEMON Manuals