LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Overhaul - A-240E/L, A-244L & A-245E) >> Component Disassembly & Reassembly >> Forward Clutch >> Disassembly

Forward Clutch: Disassembly

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1992 Geo Prizm, 1991 Toyota MR2, 1991 Toyota Corolla, 1991 Geo Prizm, and 1990 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove thrust washer. Remove thrust bearings and races from both sides of clutch. Remove clutch drum snap ring. Remove flange, discs and plates. Note number and location of components. See Figure. Using Clutch Spring Compressor (09351-32070) and press, compress spring retainer and return springs.
  2. Remove snap ring. Remove spring compressor, spring retainer and return springs. To remove piston from clutch drum, apply compressed air to oil passage (hole nearest piston) on rear of forward clutch shaft. Remove "O" rings from piston. If necessary, remove oil seal rings.
scientia non olet · About LEMON Manuals