Hazard Warning Switch

Ensure HAZARD-HORN and/or TURN fuses are good. Ensure flasher is good. See TURN SIGNAL FLASHER LOCATION table. With hazard warning switch removed from dash, ensure voltage is at switch wiring harness connector terminal No. 8. See Fig 1. If voltage does not exist, check/repair fuses and wiring circuit. If voltage exists, disconnect switch from connector.
Using DVOM, ensure switch continuity exists between terminals listed, with switch in specified position. See HAZARD WARNING SWITCH CONTINUITY TEST table. Replace switch if continuity is not as specified. If switch is good, check wiring circuit. See appropriate chassis wiring diagram in WIRING DIAGRAMS.

TURN SIGNAL FLASHER LOCATION

Model	Location
Paseo	Behind Instrument Panel Lower Finish Panel, Above Hood Release Lever

Fig 1: Hazard Warning Switch Terminal ID

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HAZARD WARNING SWITCH CONTINUITY TEST ⁽¹⁾

Switch Position

Terminal Numbers

Continuity Present

Off

7 & 10

Yes

4, 5, 6 & 9; 7 & 8

Yes

⁽¹⁾	Terminals No. 2 and 3 are for switch illumination bulb.