LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1992 >> Tercel LE, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Standard >> Removal & Installation >> Instrument Cluster >> Removal (Previa)

Removal (Previa)

  1. Disconnect negative battery cable. Remove steering wheel. See STEERING WHEEL .
  2. Remove 5 screws retaining steering column covers. Remove hood release lever. Remove 2 plastic screw covers and 5 retaining screws from instrument panel lower finish panel below steering column. See Figure. Remove 5 bolts retaining inner knee panel from below steering column.
  3. If equipped with tilt steering column, tilt column to lowest position. If not equipped with tilt column, disconnect combination switch and spiral cable harness connectors. Remove combination switch/spiral cable assembly and turn signal bracket from steering column.
  4. Remove instrument panel center cluster top cover (fuse/relay block cover). Remove 2 screws and 2 bolts retaining cluster finish center panel (heater control and radio panel). See Figure. Pull cluster finish center panel (with radio attached) outward enough to access and remove 2 screws retaining right side of instrument cluster finish panel.
  5. Using flat-blade screwdriver, pry instrument cluster finish panel loose from 3 retaining clips and left air duct. Remove 4 instrument cluster mounting screws. If equipped with automatic transmission(A/T), disconnect indicator cable from control lever.
  6. Ensure control lever is in "P" position. Remove cable from roller. Pull instrument cluster outward and disconnect harness connectors.
scientia non olet · About LEMON Manuals