(Land Cruiser)
- Disconnect negative battery cable. Remove steering wheel. See STEERING WHEEL . Remove steering column covers.
- Remove hood release and fuel door levers. Remove 4 screws from instrument panel lower finish panel. Pry lower finish panel loose from 2 retaining clips. See Figure.
- Disconnect combination switch harness connectors. Remove combination switch assembly and turn signal bracket from steering column.
- Remove manual choke knob. Remove ashtray and mounting bracket. See Figure. Remove 3 screws retaining instrument cluster finish center switches panel. Pry panel loose from 6 retaining clips. Disconnect switch harness connectors.
- Remove 6 retaining screws from instrument cluster finish panel and pry panel loose from 2 retaining clips and air ducts. Remove 4 screws from instrument cluster.
- Pull cluster outward enough to disconnect speedometer cable and wiring harness connectors. Remove cluster. To install, reverse removal procedure.