LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1992 >> Tercel DX, 2D Sedan, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Power Brake Unit >> Removal & Installation (Celica)

Removal & Installation (Celica)

  1. Remove wiper arms. Remove outside lower windshield molding. Remove upper suspension brace. Temporarily secure shock absorber with nuts. Remove left wheel. Remove master cylinder. See MASTER CYLINDER under REMOVAL & INSTALLATION.
  2. Remove charcoal canister, vacuum hose and lower pad. Disconnect push rod at brake pedal. Remove ignition coil, bracket and ignitor. Disconnect brakeline from flexible hose at left front brake. Remove brakeline grommet.
  3. On ABS-equipped vehicles, remove 3 brakelines from clamp on firewall. On all models, remove power brake unit. To install, reverse removal procedure. Tighten nuts to specification. See appropriate TORQUE SPECIFICATIONS  at end of article. Check and adjust push rod. See POWER BRAKE UNIT PUSH ROD . Bleed brake system. See BRAKE SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals