LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1992 >> Tercel DX, 2D Sedan, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Standard >> Removal & Installation >> Steering Wheel >> Removal (With Air Bag)

Removal (With Air Bag)

  1. Ensure front wheels are in straight-ahead position. Place ignition switch in LOCK position and remove key. Disconnect negative battery cable. Remove 2 screw covers from sides of steering wheel. See Figure. Using Torx Wrench (T30), loosen 4 air bag pad retaining screws until screw head is snug against screw case.
  2. Carefully pull air bag pad away from steering wheel enough to unlock and disconnect air bag electrical connector. DO NOT  forcefully pull on electrical connector or wiring. Place air bag pad aside with pad facing upward.
  3. Remove steering wheel lock nut and washer from steering shaft. Make alignment mark on steering shaft and steering wheel for installation reference. Using appropriate steering wheel puller, pull steering wheel from shaft while guiding spiral cable wire through steering wheel opening.
scientia non olet · About LEMON Manuals