Inspection (Cressida)
- Inspect cylinder head warpage at cylinder block and manifold areas. Replace cylinder head if warpage exceeds specification. See CYLINDER HEAD table under ENGINE SPECIFICATIONS.
- Check intake manifold, air intake chamber and exhaust manifold warpage. Replace component if warpage exceeds specification. See WARPAGE SPECIFICATIONS (CRESSIDA) table.
- Inspect cylinder block deck surface for warpage. Replace cylinder block if deck warpage exceeds specification. See CYLINDER BLOCK table under ENGINE SPECIFICATIONS. Inspect camshaft and components. See CAMSHAFT under REMOVAL & INSTALLATION.
WARPAGE SPECIFICATIONS (CRESSIDA)
| Application | Maximum Warpage: In. (mm) |
|---|---|
| Air Intake Chamber | .0039 (.099) |
| Exhaust Manifold | .0295 (.749) |
| Intake Manifold | .0039 (.099) |