Installation (Cressida & Supra)

Install pad support plates and NEW pads. Install pad wear indicators, anti-squeal shims and anti-rattle springs. Apply disc brake grease to inner anti-squeal shims. DO NOT allow grease to contact rubbing face of pads. Ensure wear indicator is on bottom side of pad.
NOTE: Pushing piston into caliper bore will force fluid back into master cylinder reservoir. Remove reservoir cap when compressingpiston.
Push piston into caliper bore. DO NOT let piston dust boot wedge against edge of pads. To complete installation, reverse removal procedure. Tighten bolts to specification. See appropriate TORQUE SPECIFICATIONS table at end of article. Check reservoir fluid level.

Fig 1: Exploded View Of Rear Brake Caliper With Internal Shoe Parking Brake (Cressida & Supra)

NOTE: Some models have one or more sets of anti-squeal shims. If one set of shims is vented, place it between pad and outer anti-squeal shim.