Propeller Shaft: Inspection

Inspect rear propeller shaft for damage and runout. If shaft runout is greater than maximum, replace the shaft. Maximum runout is 0.031" (0.8 mm). See Fig 1.

Fig 1: Inspecting Propeller Shaft Runout
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Inspect spider bearings for wear and damage and axial play. See Fig 2.Check spider bearing axial play by turning the yoke while holding the shaft lightly. Bearing axial play should be less than 0.0020" (0.05 mm).

Fig 2: Inspecting Spider Bearings
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Inspect the shaft for wear or damage.Inspect the double Carden joint for wear or damage. If any problem is found, replace the front propeller shaft assembly. See Fig 3.

Fig 3: Inspecting Front Propeller Shaft Double Cardan Joint
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002