LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1990 >> 4Runner 2D Utility, 2.4 R, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Brake System Bleeding >> Pressure Tank Bleeding

Pressure Tank Bleeding

  1. Exhaust vacuum from power unit by depressing brake pedal several times.
  2. Clean the master cylinder cap and surrounding area, then remove cap. With pressure tank at least 1/2 full, connect tank to the master cylinder using proper adapter(s).
  3. Attach bleeder hose to first bleeder valve to be serviced. See BLEEDING SEQUENCE . Place other end of hose in clean transparent container. Partially fill container with clean brake fluid, until end of hose is submerged in fluid.
  4. Open release valve on pressure bleeder. Open bleeder valve 1-2 turns, noting fluid flow. When fluid flowing in to container is clear and free of air bubbles, close bleeder valve securely.
  5. Finish bleeding system in the same manner using correct sequence. Remove pressure tank from master cylinder and check fluid level of master cylinder reservoir.
BLEEDING SEQUENCE

Application Sequence
All Longest Line First
scientia non olet · About LEMON Manuals