Thrust Bearing Alignment
Check crankshaft end play at thrust bearing with a feeler gauge. If end play exceeds limit of .012" (.30 mm), replace thrust washers. Oil grooves must be facing out.
THRUST WASHER SPECIFICATIONS
| Thickness | Size In. (mm) |
|---|---|
| Standard | .1059-.1079 (2.690-2.740) |
| 0.125 O/S | .1084-.1104 (2.753-2.803) |
| 0.250 O/S | .1108-.1128 (2.815-2.865) |