Rear Pads: Installation

Install pad support plate, anti-rattle springs and pad guide plates on torque plate. Place new anti-squeal shims onto pads. Install pads in torque plate. Wear indicator should be on top edge of outer pad.
Using Piston Spanner (09719-14020), turn piston clockwise until it locks. Align pad projection with piston stopper. Swing caliper down, ensuring boot does not wedge against pad.
Install guide bolt. Install wheels. Ensure fluid level is correct. Set automatic parking brake adjuster by pumping brake pedal several times.

Fig 1: Exploded View Of Rear Caliper With Integral Parking Brake