LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Van LE, RWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> EGR System >> Component Testing >> Vacuum Switching Valve (VSV) >> Cressida & Supra (Non-Turbo)

Cressida & Supra (Non-Turbo)

  1. Connect battery terminals to VSV terminals. Apply air pressure to the inside port closest to valve assembly. Air should escape from outer port. Disconnect battery terminals. Air should not escape from outer port.
  2. Using ohmmeter, check for continuity between terminals and VSV body. If continuity exists, unit is shorted. Replace valve if defective.
  3. Using ohmmeter, measure resistance between both terminals of valve assembly. Resistance should be 38-44 ohms at 68°F (20°C). Replace valve if resistance is not within specification.
scientia non olet · About LEMON Manuals