LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Van LE, RWD >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front (2WD) >> Removal & Installation >> Upper Control Arm >> Installation (Van)

Installation (Van)

  1. Tighten upper arm-to-frame bolts to 65 ft. lbs. (88 N.m) on the front side and 112 ft. lbs. (152 N.m) on the rear side.
    NOTE: Tighten rear side nuts first.
  2. Raise spindle with jack and install ball joint onto control arm. Install and tighten 4 ball joint-to-control arm bolts to 22 ft. lbs. (29 N.m). Install cool air intake duct and caliper assembly. Install torsion bar. Check wheel alignment.
scientia non olet · About LEMON Manuals