LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Van LE, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.2L 4-CYL - VIN [Y] >> 2.2L 4-CYL - VIN [Y] >> Piston Pin Replacement

Piston Pin Replacement

  1. Check pin fit by rocking piston at right angle to pin. If any movement is felt, replace piston and pin.
  2. Using Piston Pin Remover/Replacer (09221-25022), press pin from piston. Ensure pins, pistons, and connecting rods are marked for reassembly.
  3. Thoroughly clean and inspect all components. Coat pin with engine oil. Using Piston Pin Remover/Replacer (09221-25022), press pin into piston. Piston and pin should be at 68°F (20°C) during pin removal and installation procedure. Ensure piston and connecting rod are in proper position before installing pin. See Fig 1. If fit is loose, replace piston and pin.
Fig 1: Assembling Piston & Rod
G60575Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals