LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Van LE, RWD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrument Panel - Standard >> Testing >> Oil Pressure Gauge >> Corolla RWD, MR2, Pickup & 4Runner

Corolla RWD, MR2, Pickup & 4Runner

  1. Unplug connector from sending unit. Connect positive lead from a voltmeter to terminal and negative lead to ground. Turn ignition on. Meter should vibrate near 4.5 volt position.
  2. If reading is incorrect, test gauge resistance. Resistance between oil pressure gauge terminals should be about 42-44 ohms. If resistance value is incorrect, replace oil pressure gauge.
  3. To test sending unit, unplug connector from sending unit. Test in same manner as Celica sending unit.
scientia non olet · About LEMON Manuals