LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Van LE, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Drum >> Installation

Rear Drum: Installation

  1. Set brake shoe-to-drum clearance by measuring inside diameter of brake drum and diameter of brake shoes. Turn brake adjuster until difference between diameters is .02" (.6 mm). On all models, install brake drum and adjust brakes, if required.
  2. Snug down bearing nut. Loosen until hub can be turned by hand. Tighten nut until bearing preload of 1.1-19.2 lbs. (.5-6.0 kg) is obtained. Install cotter pin.
scientia non olet · About LEMON Manuals