Removal & Installation (Front Door)

Remove door inside handle bezel.
Remove armrest or pull handle.
Remove window regulator handle by pulling off the snap ring with a cloth. See Fig 1. Then remove the regulator handle and plate.

Fig 1: Removing Snap Ring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Remove the courtesy light.

NOTE: Tape screwdriver tip before use.

Insert a screwdriver between the retainers and the door panel to pry it loose. Tape the screwdriver tip before use.
On models with power windows, disconnect the wiring connector. Remove the door trim panel. See Figure.
To install, reverse removal procedure.