LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> MR2 Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Rear Drum R & I >> Installation

Rear Drum R & I: Installation

  1. Set brake shoe-to-drum clearance by measuring inside diameter of brake drum and diameter of brake shoes. Turn brake adjuster until difference between diameters is .02" (.6 mm). On all models except Tercel Sedan, install brake drum and adjust brakes, if required.
  2. On Tercel Sedan, pack bearings and fill inside of axle hub with "MP" grease. Snug down bearing nut. Loosen until hub can be turned by hand. Tighten nut until bearing preload of 1.1-19.2 lbs. (.5-6.0 kg) is obtained. Install cotter pin.
scientia non olet · About LEMON Manuals