LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> MR2 Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Rear Axle Bearing & Oil Seal R & I >> Removal (Corolla RWD, 4WD Tercel & Van)

Removal (Corolla RWD, 4WD Tercel & Van)

  1. With wheel and brake drum removed, remove 4 backing plate mounting nuts. Using Axle Shaft Puller (09520-00031), remove axle shaft. Maximum shaft runout is .059" (1.5 mm).
  2. Maximum flange runout is .004" (.1 mm). Using grinder, grind down inner bearing retainer of axle shaft and cut off with chisel and hammer.
  3. Using Rear Axle Shaft Bearing Remover (09527-30010 for Corolla with disc brake or 09527-20011 for all others), press bearing from axle shaft. Use Oil Seal Puller (09308-00010) to remove oil seal from housing. Clean all parts.
scientia non olet · About LEMON Manuals