LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> MR2 Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Front Wheel Bearing & Oil Seal R & I >> Removal (CAMRY, CELICA, Corolla Fwd & Tercel)

Removal (CAMRY, CELICA, Corolla Fwd & Tercel)

  1. Remove cotter pin and bearing lock nut cap. Hold foot on brake pedal and loosen bearing lock nut. Remove brake caliper from steering knuckle and suspend on wire. Remove brake disc.
  2. Remove cotter pin and nut from end of tie rod. Using tie rod end puller, disconnect tie rod end from steering knuckle. Place matchmarks on shock absorber lower bracket and camber adjust cam. Separate steering knuckle from shock absorber.
  3. Remove 2 bolts holding ball joint to steering knuckle and separate. Using 2-jaw puller, remove axle hub from drive shaft and place steering knuckle in vise.
  4. Using screwdriver, remove dust deflector. Using slide hammer with inside puller, pull oil seal out of steering knuckle. Remove snap ring from inside housing. Remove 3 bolts holding brake dust cover to steering knuckle.
  5. Using 2-jaw puller, push axle hub out of steering knuckle. Remove inside bearing inner race from bearing. Using inside puller, pull oil seal out of steering knuckle.
  6. Using 2-jaw puller, pull inner race of outer bearing from axle hub. Install outside bearing inner race on bearing to be removed. Using press with driver and support for knuckle, press bearing out of steering knuckle.
scientia non olet · About LEMON Manuals