LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Corolla LE, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL 8-Valve & 1.6L 4-CYL 8-Valve - VIN [A] >> Overhaul >> Crankshaft >> Removal

1.5L 4-CYL 8-Valve & 1.6L 4-CYL 8-Valve - VIN [A]: Overhaul: Crankshaft: Removal

  1. Remove engine from vehicle. Remove drive belts and front covers. Remove valve timing belt. Secure crankshaft and remove flywheel or drive plate, oil pan, oil pump and cylinder head. Remove piston and rod assemblies. Using punch, mark rods and caps for reassembly reference.
  2. Remove main bearing caps and arrange caps, inserts and thrust washers in order. Remove rear oil seal retainer. DO NOT  damage crankshaft sealing surface. Remove crankshaft. Remove upper main bearing halves.
NOTE: If replacing main bearing, replace with one having the same number as marked on cylinder block. There are 3 sizes of standard bearings, marked 1, 2 or 3 accordingly.
scientia non olet · About LEMON Manuals