LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Camry Base, Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear (Fwd) >> Removal & Installation >> Wheel Bearings >> Installation

Wheel Bearings: Installation

  1. Use Driver (09316-60010) to press new bearing into hub. Install bearing inner races.
  2. Using Driver (09310-35010), drive oil seal into axle hub. Using Adapter (09636-20010) and Fixture (09228-22020), press inner race with axle hub onto axle shaft. Tighten axle nut to 90 ft. lbs. (123 N.m) and stake axle nut.
  3. Pack grease into new bearings, grease cap and center of hub. Place new inner bearing into hub. Using Seal Driver (09608-20011), drive new seal into hub. Apply multipurpose grease to axle seal.
scientia non olet · About LEMON Manuals