LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1987 >> Camry Base, Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear (Fwd) >> Removal & Installation >> Suspension Arm >> Installation

Suspension Arm: Installation

  1. To install, connect but DO NOT tighten front suspension arm to body and axle carrier with nuts and bolts. Install but DO NOT tighten rear suspension arm to body with cam (align cam plate match mark). When installing front suspension arm to body, make sure lip of nut is resting on bracket flange, NOT over it. When connecting front suspension arm to axle carrier, insert lip of nut into hole on suspension arm.
  2. Install but DO NOT tighten rear suspension arm to axle carrier with nut and bolt. Be sure lip of nut is resting on bracket flange, not over it. Remove jack stands and bounce vehicle to stabilize suspension. Tighten bolts to 64 ft. lbs. (87 N.m), with vehicle resting on suspension. Check rear wheel alignment.
scientia non olet · About LEMON Manuals