LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1986 >> MR2 Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL DOHC - VIN [A] >> Removal & Installation >> Engine >> Removal (MR2)

Removal (MR2)

  1. Disconnect battery. Remove fuel tank protector and engine undercover. Drain engine oil and coolant. Remove air cleaner assembly. Remove accelerator link and speedometer cable clamp.
  2. Identify and disconnect vacuum hoses. Disconnect heater and radiator hoses. Remove PCV hose. Remove EGR valve. Remove cold start injector pipe. Remove pulsation damper and pressure regulator.
  3. Disconnect spark plug wires. Identify and disconnect engine-to-chassis electrical connections at engine. Remove engine sub wiring harness and set aside. Disconnect speedometer cable. Remove transaxle protector.
  4. If equipped, remove air conditioner belt and compressor. Suspend compressor out of way without discharging system. Disconnect shift control cables. Remove clutch release cylinder with bracket. Disconnect oil cooler hoses. Remove front exhaust pipe.
  5. Remove drive axles from transaxle. Remove flywheel housing undercover. Remove front and rear lower mounting insulators. Support engine and transaxle on engine cradle. Remove right and left upper mounting insulators. Slowly raise vehicle off engine and transaxle. Remove starter and transaxle from engine and mount engine to stand.
scientia non olet · About LEMON Manuals