LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1986 >> MR2 Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL DOHC - VIN [A] >> Overhaul >> Crankshaft >> Inspection

1.6L 4-CYL DOHC - VIN [A]: Overhaul: Crankshaft: Inspection

  1. Check crankshaft journals and crankpins for scoring, wear, cracks, taper and out-of-round. Maximum taper and out-of-round limit is .0008" (.020 mm). If beyond limits, replace crankshaft.
  2. Check crankshaft for bend by placing on "V" blocks. Use dial indicator at center journal. Maximum limit is .0024" (.060 mm) or less. If beyond limits, replace crankshaft.
    NOTE: The pilot bearing in the crankshaft rear opening is permanently lubricated and requires no cleaning or lubrication.
  3. Inspect crankshaft rear end pilot bearing. If damaged or excessively worn, replace pilot bearing using Bearing Remover (09303-35011) and Bearing Installer (09304-30012).
  4. Check flywheel friction surface for cracks, damage or wear. Measure runout using dial indicator. Runout limit is .008" (.20 mm). Resurface or replace if beyond limits. Check tooth surfaces of ring gear for flaws or wear. Replace as necessary.
NOTE: Main bearing caps are numbered and must be installed with arrows facing forward.
scientia non olet · About LEMON Manuals