LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1986 >> MR2 Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL DOHC - VIN [A] >> Engine Lubrication >> Water Pump >> Removal

Water Pump: Removal

  1. Drain cooling system. Remove alternator drive belt. On 4A-GE, remove fan shroud and fluid coupling (A/C only), fan, water pump pulley, and drive belt. On 4A-GEL, remove A/C compressor belt, if equipped.
  2. Remove water outlet housing, by-pass pipe, water inlet housing, thermostat, timing belt upper cover and oil dipstick tube. Disconnect heater outlet hose from pipe and remove heater outlet pipe mounting bolt. Remove water pump.
scientia non olet · About LEMON Manuals