Oil Pump: Installation
Check that mating surfaces are clean. Ensure pump drive gear spline teeth engage with large teeth of crankshaft. Using RTV silicone base sealant, install oil pan. Complete installation by reversing removal procedure.
OIL PUMP SPECIFICATIONS
| Application | In. (mm) | Limit In. (mm) | |
|---|---|---|---|
| Drive Gear | |||
| Tip-to-Cresent Clearance | .004-.010 (.10-.25) | .014 (.35) | |
| Driven Gear | |||
| Tip-to-Cresent Clearance | .002-.012 (.06-.31) | .014 (.35) | |
| Gear Side Clearance | .001-.003 (.03-.08) | .004 (.10) | |
| Driven Gear-to-Body Clearance | .004-.008 (.10-.19) | .008 (.20) | |