LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1986 >> Camry LE, 4D Hatchback >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Axle Hub, Carrier & Shaft >> Installation

Axle Hub, Carrier & Shaft: Installation

  1. Place axle carrier in mounting position. Install nuts and bolts holding axle carrier to shock absorber. Tighten nuts to 119 ft. lbs. (162 N.m). Install but DO NOT tighten nuts and bolts to front and rear suspension arm (install lip of nut into hole on suspension arm).
  2. Install but DO NOT tighten nut and bolt holding axle carrier to strut rod (insert lip of nut into groove on bracket). Install NEW "O" ring to axle carrier.
  3. Install axle hub assembly and tighten bolts to 59 ft. lbs. (80 N.m). Install brake drum and hub assembly.
  4. Connect brake tube to wheel cylinder. Bleed brake system. Lower vehicle to ground and bounce to stabilize suspension. With weight of vehicle on suspension, tighten axle carrier mounting bolts. Check rear wheel alignment.
scientia non olet · About LEMON Manuals