LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1986 >> Camry LE, 4D Hatchback >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL 8 & 16-Valve - VIN [S] >> Overhaul >> Crankshaft Rear Oil Seal >> Removal & Installation

Removal & Installation

  1. With engine/transaxle assembly removed from vehicle and separated, remove flywheel or drive plate. Remove rear oil seal retainer. Tap oil seal out using hammer and drift. DO NOT  damage oil seal contact surface of retainer. Apply grease to new oil seal lip. Using Seal Installer (09223-63010), install new seal.
  2. If rear oil seal retainer is left installed, use a knife to cut off lip of oil seal. Using screwdriver, carefully pry out seal. DO NOT  damage seal contact surface of retainer or seal lip contact surface of crankshaft.
  3. Inspect seal lip contact surface of crankshaft for damage and replace as necessary. Apply grease to new oil seal lip. Using Seal Installer (09223-63010), install new oil seal.
scientia non olet · About LEMON Manuals