LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1986 >> 4Runner Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Axle Bearing & Oil Seal >> Removal (Van)

Removal (Van)

  1. With wheel and brake drum removed, remove 4 backing plate mounting nuts. Using Axle Shaft Puller (09520-00031), remove axle shaft. Maximum shaft runout is .079" (2 mm).
  2. Maximum flange runout is .008" (.2 mm). Using grinder, grind down inner bearing retainer of axle shaft and cut off with chisel and hammer.
  3. Using Rear Axle Shaft Bearing Remover (09527-21011), press bearing from axle shaft. Use Oil Seal Puller (09308-00010) to remove oil seal from housing. Clean all parts.
scientia non olet · About LEMON Manuals