LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1986 >> 4Runner Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Vacuum Pump >> Inspection

Vacuum Pump: Inspection

  1. Inspect end cover and casing for damage or wear. Measure blade with calipers. Minimum width of blade is .2343" (5.95 mm). Minimum height is .524" (13.3 mm) and minimum length is .9047" (22.98 mm).
  2. Place rotor on alternator shaft and check for excessive play in direction of rotor spline rotation. Make sure check valve flows from union side to pump side. Make sure check valve does not allow flow from pump side to union side.
Fig 1: Exploded View of Vacuum Pump When reassembling, lightly coat new "O" rings with grease.
G50825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals