Oil Pump: Installation
- Check that mating surfaces are clean. Ensure pump drive gear spline teeth engage with large teeth of crankshaft.
- Using new seal packing No. 102 pan gasket or silicone base sealant, install oil pan. Complete installation by reversing removal procedure.
OIL PUMP SPECIFICATIONS
| Application | In. (mm) | Limit In. (mm) |
|---|---|---|
| Drive Gear Tip-to-Cresent | ||
| Clearance | .004-.010 (.10-.25) | .014 (.35) |
| Driven Gear Tip-to-Cresent | ||
| Clearance | .002-.012 (.06-.31) | .014 (.35) |
| Gear Side Clearance | .001-.003 (.03-.08) | .004 (.10) |
| Driven Gear-to-Body | ||
| Clearance | .004-.008 (.10-.19) | .008 (.20) |