LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1985 >> Pickup Base, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.4L 4-CYL & 2.4L 4-CYL Turbo - VIN [R] >> Removal & Installation >> Intake Manifold >> Removal

Intake Manifold: Removal

  1. Remove air cleaner hose and disconnect accelerator cable from injection pump. If equipped with A/C, disconnect vacuum hose from idle compensating valve.
  2. Disconnect electrical wires at glow plug current sensor connector, water temperature sensor connector, glow plug resistor wires and water temperature sender gauge connector.
  3. Remove retaining clamps and 4 injector pipes. Remove fuel inlet pipe. On 2L-T, remove turbocharger oil pipe. On both engines, disconnect accelerator connecting rod from accelerator linkage. Remove EGR pipe. Remove 6 intake manifold bolts, 2 nuts and left side engine hanger. Remove intake manifold and gasket.
scientia non olet · About LEMON Manuals