Removal & Installation: Engine: Removal

Remove engine hood, and disconnect negative battery cable. Drain cooling system. Remove air cleaner. Remove fan, radiator, shroud, hoses, and upper bracket. If equipped with air conditioning, remove and support compressor without discharging system.
Disconnect heater hoses, fuel lines, and brake booster hose from intake manifold. Disconnect and label all electrical wiring and emission control hoses to ensure proper installation.
On 22R-E and 22R-TE, remove EGR modulator and air intake chamber with throttle body. Disconnect the actuator, accelerator, and throttle cables. Disconnect and label all fuel injection wiring and vacuum hoses. On 22-R, disconnect accelerator linkage from carburetor.
On all models equipped with automatic transmission, disconnect automatic transmission throttle cable. On vehicles with power steering, remove pump from engine. DO NOT disconnect hoses. Remove shift lever and clutch slave cylinder on manual transmission models.
Raise and support vehicle. Remove exhaust pipe at manifold. Remove engine undercover. Disconnect transmission shift linkage. If equipped with automatic transmission, disconnect cooler lines.
On Celica models, remove lower side engine shock absorber. Remove steering gear housing from crossmember and suspend under vehicle.
On all models, remove drive shaft. Remove motor mount bolts (above crossmember). Attach engine hoist to engine. Place jack under transmission. Place wood block between firewall and cylinder head to prevent damage to heater hose.
Remove rear transmission mounting bracket. Lift engine and transmission from vehicle.