LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1985 >> Pickup Base, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.4L 4-CYL & 2.4L 4-CYL Turbo - VIN [R] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Apply liquid sealer at 2 front corners of engine block and position head gasket over locating dowels. Place head in position and turn camshaft so dowel is at top.
  2. Install rocker arm assembly over locating dowels and tighten head bolts in 3 steps. Continue installation in reverse of removal sequence. Ensure valve and ignition timing is properly set. Adjust valves.
Fig 1: Cylinder Head/Rocker Arm Bolt Tightening Sequence
G82204Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE: Loosen head bolts in reverse order.
scientia non olet · About LEMON Manuals