LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1982 >> Corolla SR5, 2D Hatchback >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3-TC 4-Cylinder >> Camshaft >> Camshaft Bearings

Camshaft Bearings

  1. Using bearing remover tool (09215-25010), pull out bearings 1, 2 and 5 toward front and bearings 3 and 4 toward rear. Using same tool, install new bearings in the following order: No. 4 using No. 1 as a guide, No. 2 using No. 1 as a guide and No. 3 using No. 5 as a guide.
  2. Install No. 1 bearing using No. 2 as a guide and No. 5 bearing using No. 1 and No. 4 as guides. Ensure that oil holes in bearings are aligned with oil holes in block. Bearings are available 0.005" and 0.010" (0.125 and 0.250 mm) undersize.
    NOTE: Apply liquid sealer to plug at rear of block.
scientia non olet · About LEMON Manuals