Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Corolla Base, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 2.2 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides | 1.4 | B | ||
| Combination Procedure: AXLE SEAL: Replace: | ||||
| Rear,Both | 0.8 | B | ||
| Rear,One Side | 0.6 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | Includes: Bleed Brakes. | 0.2 | B | |
| One | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: CALIPER: Overhaul: | ||||
| Single Piston,One | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: | ||||
| RWD, Front,Each | Includes: Repack Wheel Bearings. | 0.4 | B | |
| Combination Procedure: DISC ROTOR: Replace: | ||||
| 0.5 | B | |||
| Combination Procedure: WHEEL BEARING: Repack: | ||||
| Front | 0.8 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| RWD, One Side,Front | Includes: Repack Wheel Bearings. | 0.5 | B | |
| Combination Procedure: WHEEL CYLINDER: Overhaul: | ||||
| One,Off Vehicle | Includes: Bleed Brakes. | 0.5 | B | |
| One,On Vehicle | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.3 | B | |